Discussion Forum

December 30, 2009 10:26am UTC in response to Y K

Re: About Edge Vertex Distribution in Map Mesh

Hi

If you are in the GUI you can select "Mapped Mesh Parameters - Boundary - Constrained edge elements distribution" put the desire number of elements, select an element ratio >1 and Distribution method: Exponential (you do notneed to use the Edge vertex distribution, but thats another way with a better finesse).

Now I beleive that you are being "fooled" by the direction vector, if you select edges they will appear with an arrow, this is the "positive" "s" parameter direction selected by COMSOL, it is done in a systematic way, but might appear upside down from the users view, you have to live with that, and if you select a quadrant of a cylindrical shell you will notice that the two edges that you want to have an exponential are most probably with opposite "signs". This means that you have to select each one individually and use the reverse direction on one of them, Murphy say that you will select the wrong one, when you have some choice, so if this happens its just to "EDIT undo mesh" and start again.

By the way you also have boundary mesh, that does something similar, but you end up with triangles at the opposed side, I use this sometimes, and then transform them into triangles with the appropriate command, if required

Hope this helps
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

January 4, 2010 6:30am UTC in response to Y K

Re: About Edge Vertex Distribution in Map Mesh

Hi

Well if you uppgrade, think of V4 coming these days, its a rather large step in changes as the interfaces has been switched, but after some explanations on the reasons why, ad having tested it during a few days, I must admit I was rather entousastic, furthermore many of the issues that made remodelling touh has bee hihgly improved, including history of meshiong process.

by the way, try to give a progression with a minus sign on one of the edges, perhaps that does it

Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

August 27, 2010 10:58am UTC in response to Y K

Re: About Edge Vertex Distribution in Map Mesh

Hello;

I've been recently used Comsol Multhyphysics 3.4. I encounter more or less the same problem. I want to seperate my rectangular 2D axial symmettric geometry into meshes which are intenser at each individual boundaries. When I use mapped mesh parameters I specify element ratio, number of elements and distrubition (linear or exponential). But I can only get intenser meshes at 2 out of 4 boundaries.(see attached file) could you please help me to achieve this.

Thanks in advance

Best Regards

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse