Community > Discussion Forum > 3D fluid flow in an L-shaped pipe

Discussion Forum

3D fluid flow in an L-shaped pipe

Topics: Fluid Flow

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   0 Replies   Last post: September 2, 2010 8:40pm UTC
Sylvana Garcia

Sylvana Garcia

September 2, 2010 8:40pm UTC

3D fluid flow in an L-shaped pipe

Hello

I really appreciate any help. I am trying to model a 3D fluid flow model. This is an L-shaped pipe with a curved corner. I am doing a stationary model. I'm using version 4.0.
Inlet: laminar inlet, 0.05 m/s
Outlet: laminar outlet, 0 pressure
rho: 1000 kg/m^3
eta: 0.001 Pa*s
I am new with Comsol. There is a message saying there's a problem in Stationary1. I see this as a simple geometry, and it's just in preparation for more complex geometries that I'll need to model later on! Any ideas?

Thank you so much
Sylvana

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines