Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
error in geometry drawing
Posted 13 janv. 2011, 03:47 UTC−5 Geometry Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I use Matlab for my simulations and now I discovered what is causing errors. I attached my m-file and comsol file (at least when I start it then I cannot see all elements, I have to click on electrostatics or some other menus to see everything).
In my simulation I draw many small cylindrical elements. As long I draw them horizontally or vertical everything works fine, but if I want to draw the element with 45 degree angle then I get error. I don't understand the reason. Have somebody had similar issue?
I use Matlab for my simulations and now I discovered what is causing errors. I attached my m-file and comsol file (at least when I start it then I cannot see all elements, I have to click on electrostatics or some other menus to see everything).
In my simulation I draw many small cylindrical elements. As long I draw them horizontally or vertical everything works fine, but if I want to draw the element with 45 degree angle then I get error. I don't understand the reason. Have somebody had similar issue?
Attachments:
1 Reply Last Post 15 janv. 2011, 16:32 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
indeed your mph file seems corrupt, I get only error messages and cannot identify cleary why
--
Good luck
Ivar
indeed your mph file seems corrupt, I get only error messages and cannot identify cleary why
--
Good luck
Ivar