Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
2D Axisymmetric electrostatic model
Posted 3 mai 2011, 13:43 UTC−4 Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
hi,
Is it possible to have a electric potential as a boundary in a 2d antisymmetric model ?
it gives me this error :Unknown parameter pairs", Feature: Electrostatics/
I have two parallel plates fixed in a constant voltage (-100V and 100V), now I want to half my model to reduce the number of nodes using symmetric condition. how can I do this?
Best
Is it possible to have a electric potential as a boundary in a 2d antisymmetric model ?
it gives me this error :Unknown parameter pairs", Feature: Electrostatics/
I have two parallel plates fixed in a constant voltage (-100V and 100V), now I want to half my model to reduce the number of nodes using symmetric condition. how can I do this?
Best
1 Reply Last Post 16 mai 2011, 13:00 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I see a similar error in heat transfer (ht) module when using 2 geometries.
No idea as to what is the source.
Ciao
No idea as to what is the source.
Ciao