Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
3D Heat Generator
Posted 22 juin 2011, 09:51 UTC−4 Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I have never used COMSOL before and i'm trying to model a 3d heat generator. I am using version 4.2 of COMSOL.
The generator is essentially a rotating metal plate with a path running through it. the plate has a set of magnets above and below it.
I've been looking at various examples such as the 3d generator in the model libary and the permanent magnet tutorial in order to try and learn abit about what I should be doing.
Can you give me any advice on what physics I should have and how to set it up? So far I have been trying to get it to just display the magnetic field produced by the magnets when the plate is sationary and I havent been having any luck.
The model attached contains the geometry I am using.
Thank you
Robert
Attachments:
Hello Robert Middlehurst
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.