Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Identity Pairs and their usage

Please login with a confirmed email address before reporting spam

Hi,

For the first time I have to use 'identity pairs' in 4.x due to geometrical requirements (I am not using the full contact surface between subdomains but partial). I have read about the way they are used and got a little confused with my simulation results.

In the dynamic help there is a statement goes like: "If required, click the Swap source and Destination button to swap the source boundaries and the destination boundaries"

Firstly, I have further searched the requirements for the condition to call a boundary a 'source' or a 'destination' boundary with no satisfactory results for the thermal case, yet again, switching source and destination boundaries has a considerable impact on my results. Do I have to perform solver adjustments if I use these pairs like in the case of 3.4? Where can I get more information on this?

Secondly, I couldn't find any explanation about what the requirement is for swapping. Does it have to do with imported geometries where the normal vectors of the surfaces are not aligned or in general is it related with surface normal vector direction?

Thanks in advance.
Onur

1 Reply Last Post 20 déc. 2011, 15:14 UTC−5
COMSOL Moderator

Hello Onur Ilkorur

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 déc. 2011, 15:14 UTC−5
Hi,

You are surely using swept mesh. Should that be the case, then check the swept direction (source and destination) of the mesh
Hi, You are surely using swept mesh. Should that be the case, then check the swept direction (source and destination) of the mesh

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.