Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

error msg when I simulate turbulent two phase flow ( Failed to find consistent initial values.)

Please login with a confirmed email address before reporting spam

Hi,

I'm a new user of COMSOL MP4.1. I'm doing a really simple simulation of water flowing through a blended pipe.

I always encounter a problem error msg is Failed to find consistent initial values

I tried to change mesh, time steps but failed.

here I attached my mph file.

Anyone who know this problem pls help me really appreciated.

Thank you for your attention.

Dong


0 Replies Last Post 18 juil. 2011, 06:52 UTC−4
COMSOL Moderator

Hello Quanzhi Dong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.