Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Thin Film Flow (Cut Line)

Posted 27 avr. 2019, 20:32 UTC−4 Fluid & Heat, Computational Fluid Dynamics (CFD), Results & Visualization 2 Replies

Richard Rios
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi-

I have a thin film flow approximating a lubrication bearing. I want to create a 2D plot of pressure on axis and angle on the other. I am aware of how to use cut line 2D on a 2D surface to make a 1D line graph but I am not sure how to parametrize a line around the center of the cylinder.

Any help would be greatly appreciated!

Thanks!

RR

2 Replies Last Post 6 mai 2019, 18:55 UTC−4
Gunnar Andersson COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 29 avr. 2019, 02:17 UTC−4

I think that you consider using a Parameterized Curve 3D dataset.

I think that you consider using a Parameterized Curve 3D dataset.
Richard Rios
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 mai 2019, 18:55 UTC−4

I think that you consider using a Parameterized Curve 3D dataset. This worked, thanks!

>I think that you consider using a Parameterized Curve 3D dataset. This worked, thanks!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content