Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Contact Pair for Structural Mechanics
Posted 3 nov. 2011, 17:21 UTC−4 Structural Mechanics Version 4.2 2 Replies
Please login with a confirmed email address before reporting spam
Hello everyone,
I am trying to model a sphere pushing into a corner. To do so, I have created a 2D model with a load. Since the two surfaces will be tangent to the sphere surface, I use contact pair to handle the point contact issue. However, the model does not work and the two parts penetrate into each other, which is shown in the attached picture. I defined the contact pair under the the model's definition and solid mechanics. Does anyone know why this happens? I thought maybe this is a common problem that might root in a simple mistake in defining the contact.
Thank you
Pengchuan
I am trying to model a sphere pushing into a corner. To do so, I have created a 2D model with a load. Since the two surfaces will be tangent to the sphere surface, I use contact pair to handle the point contact issue. However, the model does not work and the two parts penetrate into each other, which is shown in the attached picture. I defined the contact pair under the the model's definition and solid mechanics. Does anyone know why this happens? I thought maybe this is a common problem that might root in a simple mistake in defining the contact.
Thank you
Pengchuan
Attachments:
2 Replies Last Post 3 nov. 2011, 22:32 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
It could be that you are scaling the displacements in this plot, especially since the stresses are very small. Making sure displacement scaling is off (scaling factor =1.0).
Nagi Elabbasi
Veryst Engineering
Nagi Elabbasi
Veryst Engineering
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
It could be that you are scaling the displacements in this plot, especially since the stresses are very small. Making sure displacement scaling is off (scaling factor =1.0).
Nagi Elabbasi
Veryst Engineering
Amazing. That's magic. Thank you for your reply. I really appreciate it. The problem bothers me for a long time. Thank you again.