Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to do add a constant magnetic field to a physical domain

Please login with a confirmed email address before reporting spam

I am a newcomer,and I want to ask how to add an upward magnetic field in the figure below ,Thank you



1 Reply Last Post 17 nov. 2019, 11:47 UTC−5
Edgar J. Kaiser Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 17 nov. 2019, 11:47 UTC−5
Updated: 4 years ago 17 nov. 2019, 11:49 UTC−5

Hi,

you can apply a magnetic potential to the boundaries of the model. In case of mfnc this would be the scalar potential Vm = 1[A/m]z for a field of 1 A/m in z-direction. In case of mf it is Ar = 0, Aphi = 0.5[T]r and Az = 0 for a field of 1 T in z-direction.

Of course any magnetization inside the model will distort this field.

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Hi, you can apply a magnetic potential to the boundaries of the model. In case of mfnc this would be the scalar potential Vm = 1[A/m]*z for a field of 1 A/m in z-direction. In case of mf it is Ar = 0, Aphi = 0.5[T]*r and Az = 0 for a field of 1 T in z-direction. Of course any magnetization inside the model will distort this field. Cheers Edgar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.