Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Transient two phase simulation using the phase-field method
Posted 29 janv. 2010, 15:11 UTC−5 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to simulate the transient filling of a circular capillary chamber (height 30e-6, radius 4000e-6) using the phase field method, but before reaching the outlet, the fluid is stopping always at the same point, no matter if i apply an inlet pressure of 1Pa or 1000Pa.
I tried to vary the mesh size and played with the mobility tuning factor, the mesh size and the interface thickness but I am always getting similar results. What else can I try to get the chamber completely filled?
Regards,
Jimbo
Hello Jimbo Jones
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I am encountering a similar kind of problem. Did you find any solution. Kindly let me know..