Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress Analysis

Please login with a confirmed email address before reporting spam

Hi,

I am fairly new to COMSOL and i am looking to do a simple bend / stress analysis on the object in the picture attached.

In the picture i have one sheet of a low modulus material with 2 'anchor' points. I want to apply a force to the outside edge of each anchor point so when the force is applied the sheet should bend in a 'concave' style.

I am unsure how to set up this simulation, so any advice would be fantastic.

I've seen online that I have to set up some 'contact boundaries' between the anchor points and the sheet - and make the anchor points a 'rigid domain' - but I'm not exactly certain what this means.

Thanks



0 Replies Last Post 22 juin 2021, 08:24 UTC−4
COMSOL Moderator

Hello Kieran Holmes-Martin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.