Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

boundary condition

Posted 6 juin 2012, 05:16 UTC−4 Low-Frequency Electromagnetics, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.2 1 Reply

Med Amin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi:


What are the boundary condition nécaisaire to the coupling between an ability by the electrostatic model and the model electric circuit?
(The goal is the realization of a capacitive divider)

thank you.
1 Reply Last Post 6 juin 2012, 16:20 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 juin 2012, 16:20 UTC−4
Hi

check the doc and the model library examples:

try a "Terminal" and a GND in the ES or EC physics , then link xout Terminal to CIR, and add a I vs U (or U vs I depending on your model) in the CIR physics, then link this node to the corresponding Terminal (pull down menu)

--
Good luck
Ivar
Hi check the doc and the model library examples: try a "Terminal" and a GND in the ES or EC physics , then link xout Terminal to CIR, and add a I vs U (or U vs I depending on your model) in the CIR physics, then link this node to the corresponding Terminal (pull down menu) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content