Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

why the current equals OA in magnet coil-model

Posted 14 févr. 2022, 09:50 UTC−5 Electromagnetics, Low-Frequency Electromagnetics, Structural & Acoustics, Electrochemistry 1 Reply

Krzysztof Kecik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have analzyzed the problem induced volatage in the moving magnet (example from the comsol website). Why the induced current uquals 0A, but voltage is induced? Moreover, why the coil diameter does not influences on the induced voltage.

Attachments:

1 Reply Last Post 14 févr. 2022, 22:25 UTC−5
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 14 févr. 2022, 22:25 UTC−5
Updated: 4 years ago 14 févr. 2022, 22:26 UTC−5

This is the "induced_voltage_moving_magnet.mph" model, I presume? 1. It's an open-circuit coil. If you go to Magnetic Fields --> Coil 1, then Settings --> Coil Excitation, you can see it says Current and Icoil is set to 0. If you change that to Voltage and then set Vcoil equal to zero, and re-run the model, you'll find a non-zero current (but no voltage). There are other settings there too that you might want to explore. 2. In regard to the coil diameter question, the induced voltage in the open circuit model should follow from Faraday's law, and be based on the time-changing magnetic flux through the coil. Based on that, what dependence would you expect to see? As an old movie once told me (ok, I may be paraphrasing just a bit), "follow the flux."

-------------------
Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
This is the "induced_voltage_moving_magnet.mph" model, I presume? 1. It's an **open-circuit** coil. If you go to Magnetic Fields --> Coil 1, then Settings --> Coil Excitation, you can see it says *Current* and *Icoil* is set to 0. If you change that to *Voltage* and then set *Vcoil* equal to zero, and re-run the model, you'll find a non-zero current (but no voltage). There are other settings there too that you might want to explore. 2. In regard to the coil diameter question, the induced voltage in the open circuit model should follow from Faraday's law, and be based on the time-changing magnetic flux through the coil. Based on that, what dependence would you expect to see? As an old movie once told me (ok, I may be paraphrasing just a bit), "follow the flux."

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content