Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Imposibility to select inlet/outlet

Posted 19 juin 2023, 19:17 UTC−4 1 Reply

Cristina González
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello eveyone,

I want to simulate an electrochemical cell. However, I have problems for selecting the H2 and O2 inlet and outlets to define the boundary conditions. Specifically, I followed these steps: Physics toolbar --> Atributes --> H2 inlet. The next step should be selecting "Anode inlet" from the drop-down menu of the "Boundary selection" section . However, I cannot select any of the domains I have defined previously.

Could you help me to solve this issue?

Thanks,

1 Reply Last Post 20 juin 2023, 08:01 UTC−4
Igor Rusu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 months ago 20 juin 2023, 08:01 UTC−4

Please post your model if you want assistance, otherwise it is hard to say what the issue might be.

Please post your model if you want assistance, otherwise it is hard to say what the issue might be.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content