initial/boundary conditions set as step dependent

Please login with a confirmed email address before reporting spam

In a study with multiple steps, I hope to use different initial/boundary conditions. If initial/boundary conditions can be set as step dependent, all steps can be run in one go during the same study. Can initial/boundary conditions be set as step dependent?


4 Replies Last Post 2 avr. 2024, 22:41 UTC−4
Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 month ago 27 mars 2024, 08:20 UTC−4

Hi Carl,

The reply here is the same as the one Henrik gave you to another question:

You can use Modify model configuration for study step in the settings for the study step.

If, however, it is only about having different sets of loads (or constraints), you may find the load case handling functionality more natural.

Best regards,

Magnus

Hi Carl, The reply here is the same as the one Henrik gave you to another question: You can use *Modify model configuration for study step* in the settings for the study step. If, however, it is only about having different sets of loads (or constraints), you may find the load case handling functionality more natural. Best regards, Magnus

Please login with a confirmed email address before reporting spam

Posted: 4 weeks ago 31 mars 2024, 01:29 UTC−4

Thank you Dr Magnus, where can we find the 'load case handling functionality'?

Thank you Dr Magnus, where can we find the 'load case handling functionality'?

Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 weeks ago 2 avr. 2024, 02:50 UTC−4

Take a look at, for example, this model:

https://www.comsol.com/model/tapered-cantilever-with-two-load-cases-12681

-------------------
Henrik Sönnerlind
COMSOL
Take a look at, for example, this model:

Please login with a confirmed email address before reporting spam

Posted: 3 weeks ago 2 avr. 2024, 22:41 UTC−4

that's very helpful thank you Drs Sönnerlind and Ringh.

that's very helpful thank you Drs Sönnerlind and Ringh.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.