Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
boundary condition : one way blocking
Posted 13 avr. 2010, 11:30 UTC−4 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I'm modelling a plate placed on supports and I'm applying a force on this one.
I'd like to know if it's possible to apply a blocking only in one way (compression).
Currently I've a blocking on Z axis but there is no difference between traction and compression. So, the results obtained are failed because the supports are also blocking the plate in traction.
I'm working on solid, stress-strain (sld) and heat transfer by conduction (ht) modes.
Thanks a lot
I'm modelling a plate placed on supports and I'm applying a force on this one.
I'd like to know if it's possible to apply a blocking only in one way (compression).
Currently I've a blocking on Z axis but there is no difference between traction and compression. So, the results obtained are failed because the supports are also blocking the plate in traction.
I'm working on solid, stress-strain (sld) and heat transfer by conduction (ht) modes.
Thanks a lot
1 Reply Last Post 13 avr. 2010, 12:44 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
take a look at the contact boundaries, and the treads thereon (try a search on the forum) you will find quite a lot about contact modelling
Good luck
Ivar
take a look at the contact boundaries, and the treads thereon (try a search on the forum) you will find quite a lot about contact modelling
Good luck
Ivar