Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Model up-scaling problems

Please login with a confirmed email address before reporting spam

Hello ,
I used comsol model for dialysis , and tried to modified it for my needs.
I applied a counter flow, which worked well. when I tried to upscale the model , It started to give rubbish.
I calculated the permeate velocity prefactor for this length, and changed the axial coordinate scale factor.
I wish to have 1mm width inner radius and 10 cm long.
No succsess, does anyone has an idea where do I go wrong?
I attached my model , and comsol manual for this model.
Thank you
OG


0 Replies Last Post 10 juin 2010, 01:12 UTC−4
COMSOL Moderator

Hello

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.