Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.
-
Time-dependent problem: noisy temperature boundary condition. Is it possible to change the noise magnitude in a sweep analysis?
read1 Replies 79 ViewsHeat TransferModeling Tools & Definitions
Maja Danovska posted 2 years ago reply 2 years ago by Edgar J. Kaiser
-
3 Replies 181 Views
Version 5.6 Heat TransferModeling Tools & Definitions
-
0 Replies 69 Views
Malihe Heidary posted 2 years ago
-
1 Replies 107 Views
Alexandr Shishkin posted 2 years ago reply 2 years ago by Robert Koslover
-
1 Replies 166 Views
Feyza Pirim posted 2 years ago reply 2 years ago by Prasanna Kumar Routray
-
Some particles have been removed from the simulation because of a failure in finding the wall intersection
read0 Replies 283 ViewsVersion 6.1 MEMS & Piezoelectric DevicesParticle Tracing for Fluid FlowStudies & Solvers
Lucas Gibbons posted 2 years ago
-
0 Replies 184 Views
Version 6.2 Results & VisualizationStructural MechanicsPhysics Interfaces
Nelson Leon posted 2 years ago
-
0 Replies 110 Views
Version 6.2 Battery Design
Filippo D'Ugo posted 2 years ago
-
0 Replies 88 Views
Version 6.1 Low-Frequency ElectromagneticsModeling Tools & DefinitionsPhysics Interfaces
Gilles Quemener posted 2 years ago
-
4 Replies 351 Views
Jehyeok Ryu posted 2 years ago reply 2 years ago by Jehyeok Ryu
