Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error during meshing

Please login with a confirmed email address before reporting spam

Kindly help me regarding this problem.
when i do the meshing then this error is generated.


Exception:
com.femlab.jni.FlNativeException: Internal error boundary respecting
Messages:
Internal error boundary respecting

Failed to respect boundary element edge on geometry face
- Face: 24
- x coordinate: -0.23185
- y coordinate: -0.006
- z coordinate: 0.24275

Failed to generate mesh for subdomain
- Subdomain: 2

Stack trace:
at delaunaytet.cpp, row 2373, ()
at delaunaytet.cpp, row 4841, ()
at mesh3init.cpp, row 3309, ()
at com.femlab.mesh.Mesh.init(Native Method)
at com.femlab.mesh.Mesh.init(Unknown Source)
at com.femlab.mesh.MeshInitRunnable.run(Unknown Source)
at com.femlab.server.FlRunner.run(Unknown Source)
at com.femlab.util.i.run(Unknown Source)
at com.femlab.util.ae.run(Unknown Source)

1 Reply Last Post 28 oct. 2010, 09:38 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 oct. 2010, 09:38 UTC−4
Hi

I see/saw this error (far less in V4 though) when I was meshing complex geometries, typically when the mesher had meshed all but a few parts, surrounded by other meshed entities, then the last meshing had problems to create a coherent mesh in the last volumes.

To get around, try to use edge meshes as seed, mesh from inside/centre outwards, in several steps.

meshing is somewhat an art ... ;)

--
Good luck
Ivar
Hi I see/saw this error (far less in V4 though) when I was meshing complex geometries, typically when the mesher had meshed all but a few parts, surrounded by other meshed entities, then the last meshing had problems to create a coherent mesh in the last volumes. To get around, try to use edge meshes as seed, mesh from inside/centre outwards, in several steps. meshing is somewhat an art ... ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.