Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to get min/max, and standard deviation of tempertures

Posted 4 déc. 2010, 11:39 UTC+1 3 Replies

arguani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How can I get min,max, and standard deviation of tempertures for the attached slice using FEMLAB?

Thank you

Attachments:

3 Replies Last Post 15 juil. 2011, 06:42 UTC+2
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 déc. 2010, 13:50 UTC+1
Hi

I assume its rather close to the 3.5a: export the data to matlab (but you are probably already there with FEMLAB) get the result on the desired boundary/ surface/line... via an interpolation operator and run a max or min matlab function call on the array

--
Good luck
Ivar
Hi I assume its rather close to the 3.5a: export the data to matlab (but you are probably already there with FEMLAB) get the result on the desired boundary/ surface/line... via an interpolation operator and run a max or min matlab function call on the array -- Good luck Ivar
arguani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 5 déc. 2010, 09:52 UTC+1
Ivar,

Thanks a lot for your help. I was able to export the data.
Ivar, Thanks a lot for your help. I was able to export the data.
Hu Jigang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 15 juil. 2011, 06:42 UTC+2
Hi,can you tell me how to use the 3.5a: export the data to matlab (but you are probably already there with FEMLAB) get the result on the desired boundary/ surface/line... via an interpolation operator in detail ? And wait for your reply sincerely.
Email:hujigang@hfut.edu.cn,Thank you very much.
Hi,can you tell me how to use the 3.5a: export the data to matlab (but you are probably already there with FEMLAB) get the result on the desired boundary/ surface/line... via an interpolation operator in detail ? And wait for your reply sincerely. Email:hujigang@hfut.edu.cn,Thank you very much.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content