Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Tracer particle getting stuck

Please login with a confirmed email address before reporting spam

I am using the Particle tracing model to determine the residence time; however the particles seem to get stuck in the inlet of the geometry. I have already specified the wall condition to 'bounce'.

Thanks,


0 Replies Last Post 19 juin 2017, 17:01 UTC−4
COMSOL Moderator

Hello Pedram Madadkar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.