Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

The Wrench simulation in the library

Please login with a confirmed email address before reporting spam



Hi,

I opened the file "the wrench simulation" that is in the library of COMSOL 4.1, and I did the following:

in "Study" right-click and then left-click in "Compute" and it is suppose that the model should run in the right way, however the next message appears:


The following feature has encountered a problem:

-Feature: Stationary solver 1 (sol1/s1)

-Error: Failed to find a solution.


What does it means? What is the problem? Is there an error with "the wrench simulation" that came with the COMSOL 4.1 ?

Regards,

0 Replies Last Post 11 mars 2011, 10:09 UTC−5
COMSOL Moderator

Hello Raul Rodriguez

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.