Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Slip boundary condition to rotating boundaries

Please login with a confirmed email address before reporting spam

I want to see the fluid flow for a rod using rotating machinary laminar flow module. But I did not able to figure out how to add a slip boundary condition to rotating surface.

Any suggestions??


0 Replies Last Post 5 juil. 2018, 15:27 UTC−4
COMSOL Moderator

Hello Malay Pal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.