Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Particle Tracing Will Not Let Me Select Inlet

Please login with a confirmed email address before reporting spam

Hi,

I hope someone can help. When I run a computation, I get the message:

The release or inlet features have no selection. Add a selection to at least one of the release or inlet features.

When I attempt to add an inlet and specify a wall as the inlet, nothing happens. Is there something else I have to do beforehand? Thanks in advance.


0 Replies Last Post 16 juil. 2018, 15:28 UTC−4
COMSOL Moderator

Hello Xavier Udad

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.