Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to efficiently output the resulting plots from a parametric sweep?

Please login with a confirmed email address before reporting spam

Comsol v5.3a

I have a parametric sweep solution from two varied parameters (viscosity and inflow) for a stationary fluid simulation. When I generate my reports, it only generates the plots for the currently selected set of parameters on the referenced plot. How can I output all of my plots without having to manually change the parameters on each plot one by one? Making a separate report for each doesn't seem feasible since they would all reference the same plot... The only other workaround I can see is copying the plots each plot to the clipboard and into an external document, but this is extremely time-consuming as well. Is there something I'm missing?


0 Replies Last Post 19 sept. 2018, 02:21 UTC−4
COMSOL Moderator

Hello Ross Booth

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.