Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Baw Resonator Problem

Please login with a confirmed email address before reporting spam

Hi
I am working on a baw resonator. For our simulation we have considered a 3.5a COMSOL 2D model of Thin Film Bulk Acoustic Wave Resonator in the model archives of COMSOL.

So we treid to simulate the 3d model in 4.2 but so far we are not able to achieve any displacement and correct results.We were struggling with the meshing earlier but we adopted swept mesh with tri and tetra for our model.

Our Model consist of 4 thin layers of diferent materials and we want to obtain freq. response on the aplication of the voltage.


Please inform us about the ambiguities and errors in our model so that we can conclude our research.

Thank You



Vineet Bansal
Project Associate, NPMASS
Electronic Science Department
Kurukshetra University, Haryana

0 Replies Last Post 19 avr. 2012, 07:42 UTC−4
COMSOL Moderator

Hello Vineet

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.