Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

FSI: Moving mesh (ale) vs Moving mesh

Please login with a confirmed email address before reporting spam

Hello,

I have the doubt of which of these two options select for my FSI simulation:

-The moving mesh in: Components-Definitions-Moving mesh-Deforming Domain

-The moving mesh (ale) in: Components-Moving mesh

If I use moving mesh (ale) in the results I can only see the deformation of the boundary separating the fluid from the solid, while if I use moving mesh I can see the meshes deforming properly not only in the boundary. Is there any difference between the two? Does it impact only to the visualization?

Thank you


0 Replies Last Post 5 mai 2021, 16:45 UTC−4
COMSOL Moderator

Hello James Hernández

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.