Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Element Birth/Activation for Additive Manufacturing for Thermal Simulation

Please login with a confirmed email address before reporting spam

How it is possible to achieve the element birth in a thermal simulation in order to simulate the addition of new layers. Ideally I would like for the elements to be activated as the moving heat source heats them up. However, if that is not possible, the activation of the entire layer is acceptable as well


0 Replies Last Post 19 sept. 2022, 03:41 UTC−4
COMSOL Moderator

Hello Iosif Karouanas

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.