Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D to 3D diffusion Model

Posted 23 janv. 2024, 13:24 UTC−5 1 Reply

Abdelrazik Elfar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

I am a new user and would like to ask if there is a possibilty of converting the existing 2D model to 3D model.

Kind regards, Abdelrazik Elfar

1 Reply Last Post 24 janv. 2024, 08:26 UTC−5
Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 24 janv. 2024, 08:26 UTC−5
Updated: 2 years ago 25 janv. 2024, 02:07 UTC−5

Hi Abdelrazik,

There are several options for transferring some part of a 2D model:

  • You can insert a 2D cross section from the 2D model into a 3D work plane and then extrude it into a 3D volume, for example.

  • You can copy and paste the 2D physics interfaces and materials to the 3D component. Most settings should be OK, but it's likely that you will have to add or modify the selections for boundary conditions etc.

Best regards,

Magnus

Hi Abdelrazik, There are several options for transferring some part of a 2D model: * You can insert a 2D cross section from the 2D model into a 3D work plane and then extrude it into a 3D volume, for example. * You can copy and paste the 2D physics interfaces and materials to the 3D component. Most settings should be OK, but it's likely that you will have to add or modify the selections for boundary conditions etc. Best regards, Magnus

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content