Need Help with Suction-Based Climbing Robot Simulation

Please login with a confirmed email address before reporting spam

Hi everyone,

I'm working on simulating a suction-based climbing robot using COMSOL Multiphysics. My objective is to check whether the robot will stick to a vertical surface or slip based on applied suction.

Project Details:

Suction pressure: –15,750 kPa applied to each suction pad

Robot weight: 117 N

I want to simulate how the robot behaves under gravity and suction force—whether it stays adhered or begins to slide.

I'm confused about contact pairs and setting up proper interaction between the robot body and the wall.

Also, deciding between stationary and time-dependent studies is a bit unclear.



0 Replies Last Post 7 août 2025, 16:38 UTC−4
COMSOL Moderator

Hello Saurav Kumar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.