Issue with Empty Bottom Region in Hot Fluid Injection Model

Please login with a confirmed email address before reporting spam

Hello all,

I modeled a column of hot fluid being injected into an argon domain, similar to the setup shown in the attached figure. Since the bottom boundary of the fluid column is not an external boundary, I defined the inlet at the top boundary of the column.

In my setup, I am using Level-Set to track the interface of the deposited material, along with Heat Transfer and Laminar Flow physics.

My question is: Why does the bottom part of the column remain empty during the injection process? I do not observe a continuous flow of material while the deposition is occurring.

Any suggestions or insights would be greatly appreciated!



Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.