Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

MOS Model

Please login with a confirmed email address before reporting spam

Hello,
I imported the Model MOSFET Transistor in Comsol 40a.
It runs, so normally it would be no problem, but i try to set up a familiar simulation about an AFM TIP over an Oxide smiconductor Probe. So My Question is:
In these Model the Voltage Drop over the Oxide i think it was not considered, why the modelller have this neglected?

Regards Klaus


0 Replies Last Post 17 août 2010, 05:25 UTC−4
COMSOL Moderator

Hello Klaus Eller

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.