Articles techniques et présentations

Recherche rapide

Ressources

Livres Blancs

Voyez comment la modélisation et la simulation sont utilisées par les industries La modélisation et la simulation multiphysiques pilotent l'innovation dans tous les grands secteurs d'activité et dans le monde universitaire — comme en témoignent les nombreuses utilisations présentées dans des articles et des posters techniques présentés par des ingénieurs, chercheurs et scientifiques à la Conférence COMSOL chaque année. Inspirez-vous des récents proceedings réunis ci-dessous, ou, pour trouver les présentations les plus intéressantes dans votre domaine d'intérêt, utilisez la recherche rapide.

Consultez les proceedings de la Conference COMSOL 2024

Terme recherché:

Heat Transfer and Phase Change

COMSOL® Implementation of a Viscoelastic Model with Cure-Temperature-Time Superposition for Predicting Cure Stresses and Springback in a Thermoset Resistant

B. Patham[1]
[1] General Motors Global Research and Development, India Science Lab, GM Technical Centre India.

Multi-physics simulations of the evolution of cure induced stresses in a viscoelastic thermoset polymeric resin are presented. The viscoelastic material model is implemented with a relaxation spectrum with 34 relaxation time constants. The trends in viscoelastic stresses at different ... En savoir plus

Thermo-mechanical Analysis of Steam Generator Bottom Tube Sheet of Steam Generator Test Facility

S. P. Ruhela[1], V. Vinod[1], S. Kishore[1], B. K. Sreedhar[1], I. B. Noushad[1], B. Krishnakumar[1], P. Kalyanasundaram[1], and G. Vaidyanathan[1]
[1] Fast Reactor Technology Group, Indira Gandhi Centre for Atomic Research, Kalpakkam, Tamil Nadu, India

Steam Generator Test Facility (SGTF) is set up in IGCAR to optimize the design of Steam Generators (SG) for Fast Breeder Reactors. In the SG of SGTF heat exchange takes place from sodium which enters at 525 ºC and leaves at 355 ºC temperature to the water/steam which enters at 235 ºC and ... En savoir plus

Modeling of Temperature Fluctuations in Frozen Fish

S. Kumar[1], and S. Panigrahi[1]
[1] Agricultural and Food Engineering Department, Indian Institute of Technology Kharagpur, West Bengal, India

The novel concept of distributing the food super chilled (partially frozen) in order to prolong the shelf life has been suggested in the project. The temperature of the distribution chain is envisaged to be +5C. The suggested application has the following advantages: 1) Partial ... En savoir plus

Analysis of Coupled Dynamics of Molten Salt Reactors

V. Di Marcello, A. Cammi, and L. Luzzi
Department of Energy, Nuclear Engineering Division (CeSNEF), Politecnico di Milano, Milano, Italy

This paper presents a preliminary analysis of the coupled thermo-hydrodynamics and neutronics of circulating nuclear fuel systems in a nuclear reactor that adopts a molten salt mixture. This flows up through channels in a graphite moderated core and plays the role of both heat generator ... En savoir plus

Modeling the Behavior of Single Particle during Drying Process

S. Bellur, B. Agasanpura, and C. Coronella
Chemical and Metallurgical Engineering Department, University of Nevada, Reno, Nevada, USA

The aim of the present work is the formulation of a computational model describing transport phenomena in transient biosolids drying. COMSOL Multiphysics was used to perform the simulations, with two spatial dimensions. After a time step of 0.1 s, we found that the solid reached thermal ... En savoir plus

A Multiphysics Approach to Fundamental Conjugate Drying by Forced Convection

M. de Bonis, and G. Ruocco
DITEC, Universitµa degli studi della Basilicata, Campus Macchia Romana, Potenza, Italy

Heat and mass transfer involved in drying is studied by using COMSOL 3.4. The effect of air temperature on the performance of the drying process applied to fresh food slices is scrutinized. COMSOL’s flexible formulation is exploited by using special drying kinetics for the substrate, ... En savoir plus

A Numerical Investigation on Active Chilled Beams for Indoor Air Conditioning

G. Cammarata, and G. Petrone
Department of Industrial and Mechanical Engineering, University of Catania, Catania, Italy

In this study fluid-dynamical and thermal performance of active chilled beams is investigated by 2D and 3D modelling in COMSOL Multiphysics. Three different typologies of those air conditioning systems are considered. Results, obtained for typical range of variation of operational ... En savoir plus

Modeling Joule Heating Effect on Lunar O2 Generation via Electrolytic ...

Modeling Joule Heating Effect on Lunar O₂ Generation via Electrolytic Reduction

J. Dominguez[1], S. Poizeau[2], and L. Sibille[1]

[1]ASRC Aerospace Corporation, Kennedy Space Center, Fl, USA
[2]Massachusetts Institute of Technology, Cambridge, MA, USA

Kennedy Space Center is leading research work on lunar O2 generation via electrolytic reduction of regolith. The metal oxide present in regolith is dissociated into oxygen anions and metal cations leading to the generation of gaseous oxygen at the anode and liquid metal at the cathode. ... En savoir plus

Numerical Simulation of Si Nanosecond Laser Annealing by COMSOL Multiphysics

M. Darif, and N. Semmar
GREMI-UMR6606, CNRS-Universite d’Orleans, Orléans, France

A 2D transient heat conduction model was created in COMSOL Multiphysics to simulate temperature changes in material irradiated by a KrF laser beam confined on silicon’s surface. In this paper, the obtained results are shown and discussed in case of bulk Silicon. The heat source is ... En savoir plus

Transient Conjugate Optical-thermal Fields in Thin Films Irradiated by Moving Sources: A Comparison between Back and Front Treatment

N. Bianco[1], O. Manca[2], and D. Ricci[2]
[1]Dipartimento di Energetica, Termofluidodinamica applicata e Condizionamenti ambientali, Università degli Studi di Napoli Federico II, Napoli, Italy
[2]Dipartimento di Ingegneria Aerospaziale e Meccanica, Seconda Università degli Studi di Napoli, Aversa (CE), Italy

A two dimensional instationary analysis of the conjugate optical-thermal fields induced in a multilayer thin film structure on a glass substrate by a moving Gaussian laser source is carried out numerically in order to compare back and front laser treatment processes. COMSOL Multiphysics ... En savoir plus

Premier

1021–1030 of 1232

Dernier