- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
The paper presents the numerical analysis of quench propagation in a DH magnet wound with a commercially available MgB2 wire in a fiber-glass composite matrix and operating at 20 K. The quench is induced by a small heater located on the first layer of the magnet close to the peak field ... En savoir plus
Magneto-Hydrodynamic (MHD) power generation systems were originally investigated starting from the fact that the interaction of a plasma with a magnetic field must take place at much higher temperatures than could be observed in a mechanical turbine. The main problems of traditional MHD ... En savoir plus
This paper describes a model of self-ventilated generator cooling on a 170 tons off-road mine dump truck. Considering the space restrictions of mine dump truck, the cooling systems for the generator and the in-wheel motors of the rear axle share one air inlet duct. With the action of ... En savoir plus
We simulate a Capacitive Micromachined Ultrasound Transducer (CMUT) using COMSOL Multiphysics® software. The CMUT is an electromechanical system, therefore, we couple the physics of electrical and structural mechanics to describe its dynamics. We obtain the distributions of the electric ... En savoir plus
Introduction: Existing solar cell (photovoltaic, PV) device simulation software is either open source with limited capabilities (1D only) [1,2] or extremely expensive with obscure functionality [3]. PV researchers need an accessible and versatile simulation tool to optimize existing ... En savoir plus
Accelerometers are successfully commercialized MEMS devices. COMSOL Multiphysics® has been used in the modeling, simulation and optimizing of this design. The piezoresistive accelerometer is made up of a square proof mass with flexures supporting it. The piezoresistors are placed near ... En savoir plus
Project X is a proposed proton accelerator complex at Fermilab. The CW LINAC is based on five types of resonators operating at three frequencies: half-wave, spoke, and elliptical. The low beam current for the CW operation of Project X requires cavities to operate at a high loaded Q and, ... En savoir plus
Deep Ultraviolet Light Emitting Diodes (DUV LEDs) are presently operating at a relatively low efficiency, thus large amount of LED driving power is dissipating in heat. Thermal heating degrades LED performance and decreases LED’s lifetime. The degradation of DUV LED devices with ... En savoir plus
Introduction: Chronic arterial hypertension (HTN) is a pathological condition characterized by prolonged high level of arterial blood pressure causing major damages to several human body apparata. Renal sympathetic denervation (RDN) has been found to effectively reduce systemic blood ... En savoir plus
This work describes the design and optimization of three prototypes of microelectromechanical systems (MEMS) capacitive accelerometer-based middle ear microphone. The microphone is intended for middle ear hearing aids as well as future fully implantable cochlear prosthesis. The analysis ... En savoir plus
