Articles techniques et présentations

Selective Laser Melting (SLM) offers great potential for future manufacturing technology. In order to extend its applicability for the processing of high melting materials like molybdenum fundamental process understanding is required. This can be obtained by multiphysical simulations ... En savoir plus

连续纤维增强金属基复合材料（Continuous Fiber Reinforcement Metal Matrix Composites）因其优异的性能而在汽车领域航空航天领域、兵器武装领域及电子及光学领域备受关注。但是，目前其制备工艺的不成熟，使得产品存在较多的空隙缺陷，对材料性能造成不良的影响，而压力浸渗制备的FRM相对致密、缺陷少而具有广阔的发展前景。本文以FRM的压力浸渗制备工艺为研究对象，利用Comsol Multiphysics软件进行二维数值模拟计算，分别研究了流体动力粘度、入口压力以及纤维排布方式等对渗流过程的影响，并判断出孔隙高频出现的区域 ... En savoir plus

In the scope of improvement of the industrial “ammunition cooling” process, a COMSOL Multiphysics® model is developed to transfer an existing cooling process. A device filled with a liquid explosive mixture is placed in an apparatus which controls the environment temperature. This ... En savoir plus

One of the challenges associated with the wire-arc additive manufacture (WAAM) of metals is to provide adequate inert gas shielding, not only for the molten pool, but also for the long reactive metal surface that follows it. For Ti-6Al-4V, it has been shown that increased levels of ... En savoir plus

Two friction stir welding models are presented – a global thermal model using the temperature dependent heat source and a local material flow and heat generation model allowing for detailed investigation of different contact conditions. The two models are coupled into a larger local ... En savoir plus

Latent heat storage devices use the melting enthalpy of a so-called phase change material (PCM) to store thermal energy. Open porous metals, such as 3D wire structures, allow the design of systems with tailored storage capacity and power. A geometric unit cell was identified, modelled ... En savoir plus

The induction heating coils used in the plutonium casting furnaces at the Los Alamos National Laboratory are studied here. A cylindrical graphite test article has been built, instrumented with thermocouples, and heated in the induction coil that is normally used to preheat the molds ... En savoir plus

Actual trends in lightweight construction and safety-relevant technologies cause an increasing demand for reliable design of joining connections. Increasing power density and compact design require dimensioning of joints with low safety factors. Thereby additional security measures are ... En savoir plus

Laser welding is often considered to be a superior technique over different conventional welding methods and has been gradually evolved as an efficient manufacturing process. It is a high energy density fabrication process and generally employed for fabricating intricate shapes/contours ... En savoir plus

To receive a stable quality in the injection molding process in the view of mechanically and thermally highly stressed components made by reactive resin systems, it is necessary to understand the material state along the processing chain. Up to date no measuring technology is available ... En savoir plus