Articles techniques et présentations

In this contribution we present the results of the numerical modeling and performance optimization study of a diaphragm pump for drug infusion. The main objective is to develop a numerical model that replicates the pumping cycle (400ms) and also provides indications about the variation ... En savoir plus

In this paper a poly-optimization of the design of the electromechanical actuator is presented. The shape of the actuator is defined by the decision variables. The number of decision variables under consideration is up to ten but in the next step while the multi-coils system will be ... En savoir plus

Arterial disease, especially Coronary Artery Disease (CAD) is one of the leading causes of premature morbidity and mortality. During the flow, blood interacts with vessel wall mechanically and chemically which modulates the plaque formation in blood vessel leading to coronary artery ... En savoir plus

The aim of the study is to predict the formation of porosities in the case of spot laser welding of tantalum. During the interaction, a deep and narrow cavity, called the keyhole, is generated. At the end of the interaction, surface tension provokes the collapse of the keyhole. Gas ... En savoir plus

Significant volumes of the worlds proved reserves are in dolostone reservoirs. Scope for recovery and success/upside of new exploration plays depend on the chances of encountering dolostone reservoirs with good reservoir properties. Although dolostones make excellent reservoirs in ... En savoir plus

The aim of the present work is the formulation of a theoretical model describing the transport phenomena involved in food drying process. The attention has been focused on the simultaneous transfer of momentum, heat and mass occurring in a convective drier where hot dry air flows, in ... En savoir plus

On one hand, the "float polishing" process consists of a tin lap having many concentric grooves, cut from a flat by single point diamond turning. This lap is rotated above a hydrostatic bearing spindle of high rigidity, damping and rotational accuracy. The optical surface thus floats ... En savoir plus

The rapid development of electronic devices leads to more demand for efficient cooling techniques. Porous media represent a convincing passive cooling enhancer due to its large contact surface area to volume ratio and intense mixing of fluid flow. In the present work, numerical studies ... En savoir plus

The tertiary current distributions on the wafer in a plating cell are studied in this work. An acid copper sulfate electrolyte composed of CuSO4/5H2O of 2.4 g/L and H2SO4 of 90 g/L is taken into account for copper deposition on the wafer. The solution of shear-plate agitating fluid ... En savoir plus

It is well known that the convergence rate of a numerical model is significantly reduced, when the genuine character of the setting with differential equation and boundary condition is not given anymore. Here we examine the decrease of convergence order for models using COMSOL in which ... En savoir plus