Articles techniques et présentations

The High Flux Isotope Reactor (HFIR) at the Oak Ridge National Laboratory (ORNL) is an 85 MW, light-water moderated, research reactor that operates at low temperature and high pressure. The HFIR is presently scheduled to convert from a high enriched uranium fuel (HEU) to a low enriched ... En savoir plus

Powder metallurgy is a key technology for manufacturing advanced components based on TiAl alloys. Cold compaction is the primary step to produce green parts. Cold deformation of TiAl powder is difficult due to its typical poor ductility. Plastic deformation and cracking susceptibility of ... En savoir plus

The Finite Element Method (FEM) has become an established numerical tool used for different academic and industrial purposes. It allows the prediction of weld pool geometry, thermal cycle, final distortion and residual stress field during and after fusion welding. The capability of the ... En savoir plus

Fluorescence Diffuse Optical Tomography (FDOT) uses Near Infra-Red (NIR) light to monitor physiological changes in internal organs. NIR light being less energetic in nature can be used for continuous monitoring of tumor infected biological tissue, neonatal brain and many such ... En savoir plus

Using 2D viscoelastic plane strain models we investigate the dependency of the stress field of slabs on geometry and kinematics of subduction zones (relative velocity of interacting plates and their absolute velocity with respect to the mantle). We conclude that the concentration of Von ... En savoir plus

Gallium Nitride (GaN) is a very interesting and highly promising material system for both optical and microwave high-power electronic applications. It plays a crucial role today in the most promising technology for high power, high-frequency circuits: AlGaN/GaN HEMTs. GaN HEMTs ... En savoir plus

Dilution’s issue during dry machining have raised the interest’s environmental researchers and engineers. In fact, the sampling of dust emitted during dry machining was a serious problem for air quality evaluation at the workplace. Furthermore, the best sampling of fine and ultrafine ... En savoir plus

Predicting the optimum thickness and gap size between n-type and p-type legs of micro thermoelectric devices are the major challenges in designing micro thermo electric generators. We have reported the gap size and optimal thickness for optimal output power. We found that the gap size ... En savoir plus

The physics of rotating cups and disks is an important research subject in many areas of engineering. The rotating cup/disk has been employed in many industrial applications such as spin-coating of phosphor on television screens or photoresist films on silicon wafer, concentrating ... En savoir plus

Reynolds equation is used to analyze fluid flow through small gaps. As such, the solution of Reynolds equation provides critical information for a wide range of tribological problems. In any case where a lubricant resides between two moving surfaces, the Reynolds equation can be used to ... En savoir plus