- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
Introduction - The ability to achieve rapid and homogeneous mixing at microscales is one of the essential requirements for various lab-on-a-chip applications [1]. The flow at microscales is characterized by low Reynolds number, resulting in laminar flow patterns. Thus, the mixing at ... En savoir plus
In this paper it is shown how the equivalent circuit parameters of a MEMS resonator can be simply obtained from an eigenfrequency simulation. Additionally, it is demonstrated that the Q-factor as a result of support losses in a MEMS resonator can be determined using a matched boundary ... En savoir plus
A problem of damage prediction in aircraft structure and its non-destructive evaluation is very important for aircraft structural health assessment. The analysis of the features of direct impact of thin-walled laminate component of aircraft was performed by COMSOL Multiphysics software. ... En savoir plus
COMSOL Multiphysics was used to design a binocular load cell. A three-dimensional linear solid model of the load cell spring element was studied to quantify the high-strain regions under loading conditions. The load cell was fabricated from 6061 aluminum, and general purpose Constantin ... En savoir plus
Marco Cati graduated cum laude and encomium citation in electronic engineering in 2001 from the University of Florence, where in 2005 he also received a Ph. D. degree in electronic engineering. In 2005 he joined the Research & Development Department of Esaote where he is currently in ... En savoir plus
Charge transport behavior must be considered in developing HVDC design. In microscopic level, the space charge and conduction mechanisms are related with energy band‐gap and shallow/deep trap distribution and these come from chemical defects, physical disorder and impurities or by ... En savoir plus
This paper presents an ongoing effort, motivated by developing self-contained sensors for structural health monitoring of inflatable structures, to model the process of extracting useable electrical power from the mechanical vibrations of thin, prestressed membrane structures. Energy ... En savoir plus
High frequency side-scan sonar, to be fitted on a miniaturized submersible explorer, have been simulated and built. The purpose of this study is to see if COMSOL Multiphysics® can be used to predict the performance of the sonar, especially the beam width, setting the resolution of ... En savoir plus
An experimental program has been developed, with the purpose of evaluating the reliability in building diagnosis and characterization of an integrated analysis of several parameters, associated with acoustic waves propagating through the material. The Direct Transmission Technique has ... En savoir plus
The simulation of a micromirror using polyimide as the structural material is presented. The simulation was used to verify the initial design parameters and to explore the different characteristics of the electromechanical device. For simulation simplicity the electrodes are integrated ... En savoir plus
