Articles techniques et présentations

Large centrifugal compressors, which are commonly applied in the oil and gas and in the process industry, may fail due to vibrations of the impeller. These vibrations are induced by pressure pulsations in a compressor stage. These vibrations can be especially strong in so-called dense ... En savoir plus

For the SAFARI Imaging Spectrometer, part of the SPICA satellite payload, a Calibration Source is under development. Challenges in the design include the low cooling power (few mW) available at cryogenic temperatures. COMSOL Multiphysics® simulations were used extensively in the design ... En savoir plus

In the modern food industry one of the most important problems to face is to preserve products from deterioration: a widely used solution is the convective foods drying. Drying is based on a simultaneous transfer of both heat and water that takes place when dry and warm air flows around ... En savoir plus

A comparative study is done using optimized single axis accelerometer and dual axis and double gimbal accelerometers are designed with different cantilever beam types i.e. perforated, non perforated, spring type and cross spring type. The models are simulated to find the most sensitive ... En savoir plus

Heat transfer in a plane shear flow configuration consisting of two infinitely long parallel plates is considered. In laminar flows over undulated substrates eddies can be generated due to the kinematical constraints. A closed form analytical solution for the velocity field, based on ... En savoir plus

Solar radiation is a prominent contributor of energy in buildings, and can be transmitted directly into a building through opaque surfaces, but it can also be absorbed by building components (i.e. walls, roofs etc.). This study discusses the use and effect of ventilated facades, with an ... En savoir plus

Engineering design studies of the feasibility of conversion of the High Flux Isotope Reactor (HFIR) from high-enriched uranium to low-enriched uranium fuel are ongoing at ORNL as part of an effort sponsored by the U.S. Global Threat Reduction Initiative program. HFIR is a very high flux, ... En savoir plus

In The Netherlands rising dampness problems due to flooding of rivers and high groundwater levels form an essential treat for monumental buildings and heritage. A number of cases exists where rising dampness problems lead to the deterioration of wall finishes but also of valuable wall ... En savoir plus

COMSOL-based modeling software developed at Ostendo Technologies allows detailed simulation of semiconductor lasers and light-emitting diodes. In this work, we study the inhomogeneity of the carrier injection into optically active quantum wells of polar and nonpolar III-nitride light ... En savoir plus

The main mechanisms of acoustic attenuation in a bundle of fibres typical of lightweight fibrous porous materials are the dynamic viscous drag forces on the surface of the fibres, and the thermal heat transfer between the solid fibres and the surrounding fluid. Microstructure models ... En savoir plus