- Bridging the Terahertz Gap
- Modeling the Lithium-Ion Battery
- Protection contre la Corrosion
- Modélisation des batteries
- Modélisation et Simulation dans le développement des piles à combustible
- Modélisation thermique des petits satellites
- Analyse électro-vibroacoustique d'un transducteur à armature équilibrée
Consultez les proceedings de la Conference COMSOL 2024
In regular biosensors, the detected bacteria have to be in drawn towards the sensing area. To increase the sensitivity of the biosensors, bacteria should be drawn towards the sensing area, which can be achieved by dielectrophoresis (DEP). DEP is a mechanism which is used to move ... En savoir plus
The wide bandgap semiconductor silicon carbide (SiC) has drawn increasing attention in recent years as a promising material for high-power, high-frequency, and high-temperature operating devices. These outstanding properties of SiC make it a good candidate to replace silicon in many ... En savoir plus
In the framework of the EURAMET project 16NRM05, a novel ionization gauge was developed. The goal was to develop a more stable ionization gauge that could be suitable for standardization. The AC/DC Module and the Particle Tracing Module in COMSOL® have been used to design and model the ... En savoir plus
Normally, power lines for electrical power distribution are shielded such that there is (almost) no magnetic field outside the cable. In a substation, these cables are connected to transformers via unshielded components such as switching boards and busbars. Thus, magnetic fields are ... En savoir plus
In applications like nuclear reactors or particle accelerators, mechanical components near a source of radiation develop radiation damage. This typically means a change in tensile properties and fracture toughness, which depends on the radiation dose (commonly measured in ‘displacements ... En savoir plus
The synthesis of the superheavy elements and investigations of their nuclear, atomic and chemical properties are at the scientific forefront. Experiments are challenging due to the extremely low production rates and short half-lives [1]. A new universal high-density gas stopping cell ... En savoir plus
Introduction: Mechanical ventilation in the ICU can result in complications, including ventilator-induced diaphragmatic dysfunction (VIDD), leading to extended hospital stays and increased costs. This abstract presents a novel approach using multiple esophageal electrodes for phrenic ... En savoir plus
As part of our primary research focus, we explore the phenomenon of non-radiative resonance energy transfer (RET) between a pair of dipoles positioned within a hyperbolic metamaterial (HMM). Our investigation reveals that the presence of an HMM can fundamentally alter these non-radiative ... En savoir plus
The transport sector is one of the largest emitters of climate-effecting emissions. Thus, a major transformation in this sector is necessary to achieve Germanys and EUs ambitious goals of CO2 neutrality. In these transitions, fossil fuel-based engines will be replaced by sustainable ... En savoir plus
Modern electrical vehicle motors require a precise current control over the rotation of the rotor. These motors have high performance, but their control requirement impose a precise knowledge of the rotor angular position. Rotor position sensor (RPS) are traditionally designed using ... En savoir plus
