Articles techniques et présentations

Electronic Crystals are common forms of organization of charge in solids. They appear widely from nano-structure semiconductors to synthetic organic conductors. Charge density wave, the best treated kind of electronic crystal, can readjust its elementary units by creation of topological ... En savoir plus

Impact monitoring has been extensively studied by several researchers and it has been shown that damage extent can be correlated with the impact magnitude. In order to make the process cost-effective, simulation of the impact has been performed, to get the big training data set from ... En savoir plus

This paper presents a FEA approach to estimate temperature rise and thermal stress experienced in PZT/Solid structure due to internal heat generation and dynamic excitation. The power dissipative density consumed by structural damping of the mass structure, internal heat generation due ... En savoir plus

This work focuses on the numerical analysis conducted on the prototype sensor for the measurement of highly concentrated radiative heat fluxes, based on an inverse heat transfer method, realized at the ENEA Portici Research Center in collaboration with the DETEC department of the ... En savoir plus

Shielded transportation casks are commonly used for transportation and storage of radioactive waste materials. Design approval of such casks by regulatory authority is subject to its compliance with a thermal test (among other tests) Due to exposure of cask to fire , there is a ... En savoir plus

This paper highlights the use of the COMSOL Multiphysics® software during the design process of a thermal cycling system for regulated PCM phase transitioning. The primary purpose of the simulations was to predict the system behavior in response to an ON/OFF temperature control system ... En savoir plus

Focused ultrasound systems guided by magnetic resonance imaging (MRI) and thermometry have recently made possible the non-invasive thermal ablation of benign tumors such as uterine fibroids in clinical practice. Much more work is however required in order to make this technology ... En savoir plus

In recent years, the single-sided linear induction motor (SLIM) has been the most suitable choice for electric vehicles of the wheel and touchless type. The reason is simplicity in manufacturing, capability in applying direct force, moving and braking and low pollution. To study the ... En savoir plus

This paper presents steady and unsteady computational results obtained from numerical solutions of the full two-dimensional governing equations for annular internal condensing flows in a channel. This is achieved by tracking the “sharp” interface while solving the flow fields using ... En savoir plus

Digital microfluidic system based on EWOD (electrowetting-on-dielectric) technology can perform different fluidic operations on the same electrode array by simply modifying control software. One of the major challenges in EWOD device is to address each electrode individually in M x N ... En savoir plus