Articles techniques et présentations

One of the most promising categories of semiconductor-based sensors is organic electrochemical transistor (OECT), which consists of three electrodes (Source, Drain and Gate) and two active layers: electrolyte and conductive polymer. Despite the fact that OECT attracts a lot of attention ... En savoir plus

The paper brings out the designing and implementation of blood viscosity monitoring device that gives us the INR to measure the effectiveness of anti coagulant medications .When a blood vessel is damaged, clotting cascade begins that results in blood clot. This process is affected by ... En savoir plus

Impact monitoring has been extensively studied by several researchers and it has been shown that damage extent can be correlated with the impact magnitude. In order to make the process cost-effective, simulation of the impact has been performed, to get the big training data set from ... En savoir plus

Introduction: In this project, COMSOL Multiphysics® and SolidWorks® are employed to model and simulate a mechanically coupled MEMS resonator with varying masses. These resonators consist of three main components: springs on each end to allow the structure to move, a shuttle mass for ... En savoir plus

This paper deals with an integrated numerical and experimental analysis work aiming at the investigation of the thermal stress on nanowires in electronic gadgets especially computers and mobile phones. The comparative study of the nanowires are analyzed through the Thermal Stress physics ... En savoir plus

The good electrical, thermal, mechanical and chemical properties of solid organic dielectrics, such as PTFE, predestine them as good candidates for the electrical insulation of transport devices and systems. In the particular case of power converters involved in the future hybrid and ... En savoir plus

Gecko foots have inspired researchers to develop designs that can help robots to tread vertically oriented surface. These nanobots find many applications as they can perform a lot of operations more efficiently and also lower the cost of such operations. These can be employed in various ... En savoir plus

This paper explores surface charge modulated ionic conductance of closed solid-state nanopores for explaining significant nonlinear length dependent variation in ionic current in such nanopore biosensors with a view to design improved sensors without increasing fabrication cost for ... En savoir plus

In a first approach towards application of the magnetic frequency mixing technique to microfluidic structures, microplanar coils have to be designed along with sample reservoir. For this, a COMSOL Multiphysics® electrical model along with an analytical calculation is used in order to ... En savoir plus

The MEMS microphone is also called microphone chip or silicon microphone. The pressure sensitive diaphragm is etched directly into a silicon chip by MEMS techniques and is usually accompanied with integrated preamplifier. Most MEMS microphones are variants of the condenser microphone ... En savoir plus