Articles techniques et présentations

In this paper, design and analysis of a novel MEMS capacitive microphone which uses corrugations and perforations in diaphragm is presented. The corrugation and perforation in diaphragm reduces the residual stress and increases the mechanical sensitivity of diaphragm. Instead of the ... En savoir plus

AlGaN/GaN heterostructures are unique because the 2DEG at the interface is created by the difference in polarization properties of the AlGaN and the GaN layers; not due to intentional doping. In this work, a 3D model of an electrostatically actuated micro cantilever has been developed ... En savoir plus

This paper aims to demonstrate the simulation of photoacoustic signals using FEM software. The Acoustics Module of the software COMSOL Multiphysics is used to calculate the response of a differential Helmholtz resonator cell. In a second part a preliminary result obtained with the ... En savoir plus

The evaluation of defect size and nature are two most controversial topics in ultrasonic flaw detection. The operation consists of an application of ultrasonic waves to pipes in order to detect metal loss and other defects in the pipe wall due to corrosion and other degradation ... En savoir plus

Corona discharge is used in several applications such as surface treatment of polymers, photocopying or dust removal in air conditioning. Streamer formation is undesirable for most of these applications. Therefore, several studies have been dedicated to investigate the formation and ... En savoir plus

In this conference we have brought together a community that is scientifically diverse in an event that allows for inspiring contacts about the use of COMSOL Multiphysics. It is an event to connect with the Spanish and Portuguese COMSOL Multiphysics users and participate in training ... En savoir plus

The focus of this paper is to study the effect on resonance frequency and power enhancement techniques[1] of piezoelectric MEMS and modeling, design, and optimization of a piezoelectric generator based on a two-layer bending element(Figure 1) using COMSOL Multiphysics. An analytical ... En savoir plus

Cantilever beam-type transducers have been in great demand and explored widely in the recent years, typically in thin film form because of their sensor and actuator applications. The piezoelectric cantilever is the most preferred structure employed in technological applications. ... En savoir plus

Introduction: Vibration energy harvester can convert mechanical vibration energy into electrical energy and store it in battery for later use. It can create clean renewable energy from vibration movements such as walking, jumping, running, etc. This can convert energy previously wasted ... En savoir plus

The objective of the work is to propose a reliability enhancement model for antigen detection system (ADS) using bio MEMS based cantilever array sensors using heterogeneous modular redundancy technique. The reliability of the ADS is expressed in terms of the constituent sub systems which ... En savoir plus