Articles techniques et présentations

In-situ electrical heating technologies are among the most recent technologies used for bitumen recovery from tar sand and oil shale. These technologies have limited environmental impact because there is little disturbance of the land, and water and solvents are not used. Two-phase ... En savoir plus

When the dimensions of the material approach is a comparable size to the phonon mean free path, heat flow enters a new regime, the nanoscale. The Fourier and Cattaneo Equations describe bulk heat flow well, but radiative boundary terms must be considered when modeling nanoscale heat ... En savoir plus

Finite elements using COMSOL Multiphysics have been used to simulate the edge plasma in a large area capacitively coupled RF reactor. In order to reduce numerical difficulties simplified reactor edge geometries have been used. First results show the importance of electrostatic double ... En savoir plus

An optimal control problem (OCP) is studied to a PDE of elliptic type as well as state constraints. The resulting optimality system contains two PDEs, one algebraic equation and the so called complementary slackness conditions, i.e. dual products between function spaces. At this point, ... En savoir plus

A site-binding/dissociation model is used to determine surface charge in numerical studies of the equilibrium potential and ion distributions inside infinite and finite-length nano-channels. This COMSOL model allows us to investigate the response of surface (zeta) potential to ... En savoir plus

In the case of electron beam welding of copper with stainless steel, two principal cases of welding pool morphology are possible: a droplet-like microstructure where the electron beam deviates to the copper side due to the thermoelectric effect, so the volume of molten copper is much ... En savoir plus

Benchmarks are an important tool to verify computational models. In the research area of building physics, the so-called HAMSTAD (Heat, Air and Moisture Standardization) project is a very well known benchmark for the testing of simulation tools. In this paper we evaluate the use of ... En savoir plus

Murphy and Good general theory for electron emission from metal surfaces was used to predict the field-emission capabilities of ideal arrays of vertically aligned carbon nanotubes (VACNT). The Nottingham effect was taken into account in order to explain experimental observation of a ... En savoir plus

This paper presents and discusses the first phase results of a wide ranging project concerning the study and prediction of the efficiency and energy performances of natural ventilation systems existing inside historic buildings. The air flow patterns, air temperature and air velocity ... En savoir plus

Gas-liquid falling film microreactors carry out fast exothermic and mass transfer limited reactions. Since the major rate limiting steps occur on the liquid side, it is important to account for a realistic liquid film profile within the reactor simulation. Based on realistic channel ... En savoir plus