Articles techniques et présentations

Recherche rapide

Ressources

Livres Blancs

Ici vous trouverez les présentations issues des Conférences COMSOL à travers le monde. Réalisées par des utilisateurs de COMSOL Multiphysics, ces présentations explorent tous les domaines actuels d'innovation. Les applications couvrent pratiquement tous les secteurs industriels et impliquent des phénomènes électriques, mécaniques, fluidiques et chimiques. Utilisez la recherche rapide pour trouver les présentations les plus intéressantes dans votre domaine d'intérêt.

Consultez les proceedings de la Conference COMSOL 2024

Terme recherché:

Multiphysics Modeling and Simulation of MEMS based Variometer for Detecting the Vertical Speed of Aircraft in Avionics Applications

K. Umapathi[1], K. Sukirtha[2], C. Sujitha[2], K. A. Noushad[2], Venkateswaran[1], R. Poornima[1], R. Yogeswari[1]
[1]United Institute of Technology, Coimbatore, Tamil Nadu, India
[2]Sri Krishna College of Engineering and Technology, Coimbatore, Tamil Nadu, India

The objective of this work is to develop a MEMS based Variometer to measure the vertical speed and to sense the instantaneous rate of climb or descent in Aircrafts to meet the miniaturization requirements in avionics industry. The design consists of dielectric material in between two ... En savoir plus

Modeling Conventional Swing of a Cricket Ball

R. Latchman [1], A. Pooransingh [1],
[1] University of the West Indies - St. Augustine, St. Augustine, Trinidad and Tobago

Conventional swing is one phenomenon which a bowler uses to gain an advantage over the batsman. This study involved simulating conventional swing in the CFD Module of COMSOL Multiphysics® software and comparing the simulated results with experimental results of previous researchers. The ... En savoir plus

Design of MEMS based Polymer Microphone for Hearing Aid Application

V. S. Nagaraja[1], Ramanuja H. S.[1], Deepak K[1], S. L. Pinjare[1]
[1]Electronics and Communication Engineering, Nitte Meenakshi Institute of Technology, Bangalore, Karnataka, India

In this work, a MEMS based condenser microphone [1,2] using Polyimide as the diaphragm has been designed. The microphone structure has a backplate placed on top of the diaphragm. The backplate and the diaphragm are made up of polyimide. The two polyimide plates are separated by air gap ... En savoir plus

Uncertainty Analysis, Verification and Validation of a Stress Concentration in a Cantilever Beam

S. Kargar, and D. Bardot
University of Alabama, Huntsville, AL, USA

In this paper we compare the results from a bending cantilever beam experiment with the theoretical values and COMSOL finite element simulation results. In the experiment a simple cantilever beam with a hole is loaded at the end. Measurements are recorded by four strain gauges mounted on ... En savoir plus

Numerical and Experimental Studies of a Capillary Channel

M. Xu[1], Z. Wu[1], X. Wang[1]
[1]Tsinghua University, Beijing, China

Capillary effects are common in microfluidics due to large surface-to-volume ratio of flows inside microchannels. In biological or chemical analysis, capillary flow is used for the transport of liquid and mixing enhancement, without applying any external means. It’s used in biochemical ... En savoir plus

Modeling of Resonant Optical Trapping in a 2D Photonic Crystal Cavity

U.P. Dharanipathy[1], N. Descharmes[1], Z. Diao[1], M. Tonin[1], R. Houdré[1]
[1]Institut de Physique de la Matière Condensée, Ecole Polytechnique Fédérale de Lausanne (EPFL), Lausanne, Switzerland

Photonic crystals (PhC) are optical nanostructures that are widely known for their strong spatial and temporal confinement of electromagnetic radiation. Here, we study the resonant optical trapping of a single nanoparticle within a hollow circular photonic crystal cavity. The ... En savoir plus

Simulation of Radiation Dose from Diagnostic X-ray Beams

H. Chen-Mayer[1], R. E. Tosh[1]
[1]NIST, Gaithersburg, MD, USA

Direct realization of absorbed dose to water in diagnostic radiation via calorimetric methods poses many challenges since the thermal signal of interest may be less than a few microKelvin. In actual biological systems or structures, like the lung, there is the additional complication of ... En savoir plus

Ultrasensitive Mass Sensing Through Coupled Microelectromechanical Resonator Arrays

A. R. Hambarde [1], R. M. Patrikar [1],
[1] Visvesvaraya National Institute of Technology, Nagpur, Maharashtra, India

Microelectromechanical coupled resonating arrays are being used for detecting biological and chemical analytes through mass sensing. Such arrays of perfectly identical resonators can be considered as periodic, ordered, non-localized systems. The change in the eigen parameters of the ... En savoir plus

Numerical Study of Exciton States of Core?shell CdTe/CdS Nanotetrapods by using COMSOL Multiphysics

Y. Yao?and K. Sakoda
National Institute for Materials Science
University of Tsukuba
Japan

This paper showed: * The electronic states of core-shell tetrapod with various shell thickness were calculated. Lowest 20 electron and hole wave functions have A1 or T2 symmetry. * At t=1.2 nm, the carriers separation is not serious, core-shell tetrapod is not apparent type II ... En savoir plus

Novel Simulation of a Voltage-Driven Electro-Thermo-Mechanical MEMS Self-Oscillator

S. Ouenzerfi [1,2,3], H.A.C. Tilmans [2], S. El-Borgi[3,4], X. Rottenberg [2]
[1] KACST-Intel Consortium Center of Excellence in Nano-manufacturing Applications (CENA), Riyadh, KSA
[2] IMEC, Leuven, Belgium
[3] Applied Mechanics and Systems Research Laboratory, Tunisia Polytechnic School, University of Carthage, La Marsa, Tunesia
[4] Texas A&M University at Qatar, Mechanical Engineering Program, Engineering Building, Doha, Qatar

This paper presents the modeling and simulation of electro-thermo-mechanical self-oscillators, an emerging type of M/NEMS-enabled timing devices in which sustaining electronic amplifiers are not required for their operation. Indeed, they realize amplification in the mechanical domain and ... En savoir plus

Premier

591–600 of 674

Dernier