Articles techniques et présentations

Linear wave propagation through inhomogeneous structures of size R?? (Fig.1) is a computationally challenging problem, in particular when using finite element methods, due to the steep increase of the number of degrees of freedom as a function of R/?. Fortunately, when the geometry of ... En savoir plus

Multilayer planar transformers are widely implemented in power electronic applications. The design process of these elements is complicated due to the complexity of a magnetic circuit and high frequency interactions between windings. Additionally, an analytical approach to the analysis ... En savoir plus

COMSOL Multiphysics has been widely used to model the near and far-field electromagnetics (specifically, transmission and reflection spectra) of gold and silver nanoantenna arrays. We use a moving 3D mesh, thus preserving the DOF number and simply morphing the structure of the mesh ... En savoir plus

A three phase transformer with very low harmonic pollution transferred back to power line is here presented. In fact, thanks to the described setup, intermediate harmonics (5th and 7th) are not going out back to the power line feeding the primary. These results has been extensively ... En savoir plus

The feasibility of water cooling is investigated for a solid target which is integrated as the inner conductor in a magnetic horn for secondary particle focusing (pi; K) as used in conventional neutrino beam accelerator experiment. A simple axi-symmetric thermal model calculated in ... En savoir plus

INTRODUCTION: Micro Electro Mechanical Systems (MEMS) are fabricated with an in-plane fabrication technology. Out-of-plane structures can be designed to be assembled to provide thermal and electrical isolation from the substrate [1 -3]. These isolations can potentially improve the ... En savoir plus

Introduction: Vibration energy harvester can convert mechanical vibration energy into electrical energy and store it in battery for later use. It can create clean renewable energy from vibration movements such as walking, jumping, running, etc. This can convert energy previously wasted ... En savoir plus

Metallic nanoparticles (NPs) are nowadays used in various areas of biology, chemistry or physics. Focused laser beams, optical tweezers, may be used to manipulate such NPs. However, experimental studies showed that there is a discrepancy between their predicted and observed behavior. ... En savoir plus

In a solid core PCF, structural parameters and the number of rings in the cladding region decide confinement losses, dispersion coefficients as well as bending losses. This paper evaluates some of commercially available solid core photonic crystal fibers. The dispersion coefficients and ... En savoir plus

The optimisation of dimensions, materials choice of heaters in annealing furnaces are done with COMSOL Multiphysics® in 2D-axisymetry. Heat losses sources are identified and corrective actions can be taken in function of simulation results. A power saving of more than 50% is achieved ... En savoir plus