Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.
-
0 Replies 1088 Views
RF & Microwave EngineeringWave Optics
Guy Shalem posted 1 decade ago
-
0 Replies 297 Views
Version 4.3a
Eleonora posted 1 decade ago
-
Difference between defining one weak contribution at several points or several weak contributions with each located at one point
read0 Replies 411 ViewsVersion 4.3 Version 4.3a Version 4.3b Version 4.4 Modeling Tools & DefinitionsParameters, Variables, & Functions
Felix posted 1 decade ago
-
0 Replies 311 Views
Version 4.3b Results & Visualization
Afifa Basit posted 1 decade ago
-
1 Replies 523 Views
Version 4.3 Modeling Tools & DefinitionsParameters, Variables, & FunctionsResults & Visualization
SMHH posted 1 decade ago reply 1 decade ago by Eyal Spier
-
4 Replies 1621 Views
Version 4.4 Structural Mechanics
Georgios Drakopoulos posted 1 decade ago reply 1 decade ago by Georgios Drakopoulos
-
0 Replies 204 Views
Low-Frequency ElectromagneticsHeat Transfer & Phase Change
Ishant Jain posted 1 decade ago
-
I have two models, model 1 and model 2. When solving model 2, the initial value of model 2 is the result of model 1. should I set it ?
read0 Replies 306 ViewsVersion 4.3b Low-Frequency ElectromagneticsResults & VisualizationStudies & Solvers
Xin Wei posted 1 decade ago
-
0 Replies 179 Views
Darshan S posted 1 decade ago
-
0 Replies 263 Views
Nicolas Lhenry posted 1 decade ago
