Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coil simulation

Please login with a confirmed email address before reporting spam

Hi,

This is Pranith. I am simulating two coils. I want to give 5V voltage to one coil at 1 Mhz frequency and i have to see induced current and magnetic flux density normal but My problem is when i amusing terminal function to give voltage it is saying not applicable for ground function as well. can any one suggest me how to proceed further. Thanks in advanced. I am attaching my model.





Regards,
Pranith Tummala


1 Reply Last Post 11 févr. 2011, 10:55 UTC−5

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11 févr. 2011, 10:55 UTC−5
I have the same problem...
I have the same problem...

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.