Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stirring tank/Rotating Machinery problem

Please login with a confirmed email address before reporting spam

Dear all,
I was trying to add a 3d barrier inside the stirring tank. However, I'm not familiar with the rotating machinery. I don't know how to set up the boundary condition for the new barrier. The original stirring tank's file was downloaded from the comsol application gallery. I also found out that even I changed the number of baffles into zero. There's still one baffle left.

The original file is here: www.comsol.com/model/modular-mixer-turbulent-mixing-k-omega-16903
(modular_mixer.mph)

1. How to set up the boundary condition for the new barrier.
2. How to eliminate all the baffles.

Thank you


0 Replies Last Post 10 avr. 2017, 12:19 UTC−4
COMSOL Moderator

Hello James Harden

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.